<wbr id="e0ymm"></wbr>
<wbr id="e0ymm"></wbr>
<wbr id="e0ymm"></wbr>
<wbr id="e0ymm"><object id="e0ymm"></object></wbr>
<wbr id="e0ymm"></wbr>
<wbr id="e0ymm"><sup id="e0ymm"></sup></wbr>
歡迎您訪問中科聚峰機械有限公司網站!
攪拌機行業持續先行者!
點擊撥打服務熱線:400-879-1999
您的位置: 首頁 > 新聞資訊>>攪拌機潤滑系統中主油泵旋轉軸的磨損現象

新聞資訊

熱銷產品

推薦新聞

  • 安全使用規范是什么?
  • 聚峰混凝土攪拌車,您的選擇!
  • 高效作業的前提:即正確使用混凝土攪拌車
  • 聚峰帶你了解混凝土攪拌車的價格
  • 聚峰淺談自上料攪拌車
  • 中科聚峰廠家告訴你如何使用小型混凝土攪拌機

全國服務熱線

400-879-1999
新聞資訊 /news

攪拌機潤滑系統中主油泵旋轉軸的磨損現象

來源:http://www.tuanyg.com/ 日期:2022-07-01
概述:很多人對混凝土攪拌機的組成還有很多疑問,但正如你所知,混凝土攪拌機是我們生活中非常重要的設備,下面帶您了解一下攪拌機潤滑系統中主油
很多人對混凝土攪拌機的組成還有很多疑問,但正如你所知,混凝土攪拌機是我們生活中非常重要的設備,下面帶您了解一下攪拌機潤滑系統中主油泵旋轉軸的磨損現象內容。
Many people still have many questions about the composition of the concrete mixer, but as you know, the concrete mixer is a very important equipment in our life. Now let's take you to know about the wear of the rotating shaft of the main oil pump in the mixer lubrication system.
軸端泄漏引起的軸承磨損和與混合軸的摩擦導致軸端高溫。主軸端是集中的部分。在高強度應力作用下,零件的使用壽命將大大縮短。因此,需要及時更換軸封裝置中的密封圈、油封、滑動輪和旋轉輪;并將主軸的末端泄漏端側的軸承建議為原密封附件,避免尺寸的差異和磨損,可迅速損壞主軸。及時檢查潤滑系統:
Bearing wear caused by shaft end leakage and friction with the mixed shaft lead to high temperature at the shaft end. The spindle end is a concentrated part. Under the action of high strength stress, the service life of parts will be greatly shortened. Therefore, the sealing ring, oil seal, sliding wheel and rotating wheel in the shaft seal device need to be replaced in time; The bearing on the leakage end side of the end of the main shaft is suggested to be the original sealing accessory to avoid size difference and wear, which can quickly damage the main shaft. Check the lubrication system in time:
潤滑系統中的主油泵壓力表的接口柱塞不能正常工作。漸進式分油器安全閥閥芯在潤滑系統中堵塞,不能分油。
The interface plunger of the pressure gauge of the main oil pump in the lubrication system cannot work normally. The safety valve core of the progressive oil separator is blocked in the lubrication system and cannot separate oil.
由于上述原因,軸潤滑系統故障,需要更換主油泵潤滑系統。
Due to the above reasons, the shaft lubrication system fails, and the main oil pump lubrication system needs to be replaced.
如果你想使混凝土攪拌機的風險控制,應該從以下幾個方面入手:
If you want to control the risk of concrete mixer, you should start from the following aspects:
全混凝土攪拌機的成本控制。這主要是指混凝土攪拌機,因為混凝土攪拌機的投入和生產成本相對較低,易于管理。
Cost control of all concrete mixer. This mainly refers to the concrete mixer, because the investment and production cost of the concrete mixer are relatively low and easy to manage.
對整個混凝土攪拌機的生產過程進行細分,掌握各環節生產過程的成本。
Subdivide the production process of the whole concrete mixer and master the cost of each link of the production process.
混凝土攪拌機
做整個混凝土攪拌機銷售計劃,制定相應的生產和銷售計劃。
Make the whole concrete mixer sales plan, and formulate the corresponding production and sales plan.
做好全站財務審計制度,確保全資金鏈有序發展。建議是減少銷售,而不是缺乏資金鏈。
Complete the financial audit system of the whole station to ensure the orderly development of the wholly-owned gold chain. The suggestion is to reduce sales, not lack of capital chain.
此外攪拌葉片或側葉片與罐內壁之間的大異物也會使攪拌軸停止。之所以能捕捉異物,是因為混凝土攪拌器的混合葉或混凝土水箱的側壁與水箱的內壁有過大的空隙。過松小的混凝土攪拌器的混凝土皮帶也會導致混凝土攪拌器混合軸緩慢旋轉或停止旋轉,電機皮帶過松,導致傳動功率不足。
In addition, large foreign matters between the mixing blade or side blade and the inner wall of the tank will also stop the mixing shaft. The reason why foreign matters can be caught is that there is too much gap between the mixing blade of the concrete mixer or the side wall of the concrete water tank and the inner wall of the water tank. Too loose the concrete belt of the small concrete mixer will also cause the mixing shaft of the concrete mixer to rotate slowly or stop rotating, and the motor belt is too loose, resulting in insufficient transmission power.
然后如何解決攪拌機停止轉動、混凝土攪拌機過載、攪拌軸停止等問題,只需調節進料量,排出多余的材料,減少攪拌軸的旋轉負荷。當側葉片與內壁結合時,在攪拌軸停止前總是存在尖銳和劇烈的摩擦。
Then how to solve the problems such as the mixer stops rotating, the concrete mixer is overloaded, and the mixing shaft stops, just adjust the feeding amount, discharge the excess material, and reduce the rotating load of the mixing shaft. When the side blades are combined with the inner wall, there is always sharp and violent friction before the mixing shaft stops.
在這種情況下,應立即停止檢查,手動去除異物,并重新調整小混合器攪拌葉片的葉片和罐壁或側面之間的間隙。如果混凝土攪拌機混凝土皮帶太松,它可以簡單地停止后調整攪拌機混凝土帶的張力。
In this case, the inspection should be stopped immediately, the foreign matters should be removed manually, and the gap between the mixing blade of the small mixer and the tank wall or side should be readjusted. If the concrete belt of the concrete mixer is too loose, it can simply stop and adjust the tension of the concrete belt of the mixer.
以上就是問題解答的相關內容了,希望能夠幫助到大家,如對這一問題還存在任何疑問,都歡迎關注我們網站http://www.tuanyg.com并咨詢我們的工作人員,將竭誠為您服務。
The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://www.tuanyg.com And consult our staff, will serve you wholeheartedly.

截屏,微信識別二維碼

老熟女乱子伦视频,在线A片永久免费看,中文字幕aV无码免费,8090YY在线A片无码,在线视频4k岛国无码专区